3
Step by Step Assembly Instructions
Step One
1.
Insert
Double Cross Dowel (2)
into the pre drilled hole
at the top of the
Table Leg (B)
using the end of the
Spanner (5)
to help align with holes.
Note:
the mark
engraved on the double cross dowel must face towards
the holes on the leg as shown in the diagram below.
2.
Holding the
Cross Dowel (2)
in place with the spanner,
insert and tighten
2 x Threaded Bolt (1)
into the table
leg.
3.
Repeat the above steps for the other 3 table legs.
Step Two
1.
Place
Table T op (A)
up-side-down on a clean, dry & smooth surface that will not scratch the
table top.
2.
Attach the
Table Legs (B)
to the
Table Top (A)
using
Flat Washers (4),
and
Hex Nut (3)
as shown in the diagram below.
3.
Tighten the nuts with the
Spanner (5).
____________________________________________________________________________
Step Three
1.
With the help of another person, carefully turn the table the
right way up, taking care not to pivot on the legs. Place the
table on an even level surface ensuring that each leg is in full
contact with the ground.
2.
The Table is now ready to use.
