Cruisecontrol GC55 Installation manual
12
3.4.2
Mounting electric servo
The servo can be mounted in both engine bay to the body, and underneath the
dashboard. To be able to mount the servo properly 2 mounting brackets are supplied
with the universal set. In specific sets a selection has been made.
Mount the servo as follows:
Step
Action
Picture
1
Fit the mounting bracket to the servo in the desired position.
2
Secure the bracket by placing both locking washers
between the bracket and the M10-nut, with the
serrated sides facing each other.
3.5
Servo cable linkage
The bends in the servo cable have to be at least 40 cm in diameter.
The minimal distance between the servo cable and moving parts and the
exhaust system is 30cm.
The servo cable has to point straight from the adjuster and pull in a straight
line.
Possible travel for the cable linkage (see pictures § 3.5.1) depending on the
chosen pulley: red pulley = 31-38mm – yellow pulley = 18-24mm.
Adjust the servo cable with a warm engine, because of a possible cold-start
device.
Some cars hardly decelerate when the throttle valve remains slightly open.
Always allow for some free play in throttle released position.
Always check for a smooth operation of the throttle valve, throttle cable
and servo cable by operating the throttle by hand and by foot.
Make sure that they cannot jam in any way.
