© 2021 John Blue Co.
4
2.) Hydraulic Drive Configuration (P/N: CS-150-HY):
Installation:
This configuration is designed to drive the pump via a hydraulic motor.
** Note that any plumbing must be supported so that its weight does not hang off the pump, this will void the
warranty.
Storage:
After use, flush the pump with a solution that will neutralize the fluid you have been pumping, and then drain, then
fill the pump with RV antifreeze for storage.
Maintenance:
Inspect the seal reservoir fluid level using the sight window, the fluid level should be above the middle of the
window. If the fluid is dirty, drain the pump by vacuum or turning upside down, then replace with 50/50 premixed
ethylene glycol antifreeze. If fluid is cloudy, impeller side seal may be leaking.
Hydraulic Drive Specifications:
Max Hydraulic Flow :
4 GPM*
Max Hydraulic Pressure :
3000 PSI*
Pump Port (P) Size :
SAE-6
Tank Port (T) Size :
SAE-8
Gauge/Load Sense Port (M1G/LS) :
SAE-4
Hydraulic line sizes should be sized appropriately to the flow capacity of the tractor / supply and rated for
3000 PSI continuous operating pressure, for flowrates from 0-4 GPM size -6 (3/8”) hose is recommended.
*
MAXIMUM WATER FLOW FROM THE PUMP IS ACHIEVED AT 4 GPM HYDRAULIC FLOW,
HYDRAULIC
FLOW IN EXCESS OF 4 GPM OR HYDRAULIC PRESSURE IN EXCESS OF 3000 PSI CAN RESULT IN
DAMAGE TO THE HYDRAULIC MOTOR.
