10
Joerns® Assist Device and Side Rails
Vari-Care Models
© 2014 Joerns Healthcare • 6110015 RevJ • 14-2315
7. Insert the F168 rail as shown in Figure 7. Begin
with the head end bracket. With assistance, line
the foot end bracket up with the rail mounting stud
on the foot end of the rail. Insert the rail as you
did with the head end and tighten the foot end
brackets to the frame rail.
8. Before use, ensure that the retaining clips are in
place and secure (Figure 8).
Warning:
Use only the F168 Rails with the N832 Full
Rail Mount Kit
Warning: Risk of Serious Injury or Death.
Do not use
the device as an assist if the hand grip area is wet. A wet
surface may lead to the resident’s hand slipping on the
assist device and result in injury or death.
Warning:
In the event that a ground wire is disconnected
during installation, RECONNECT IT NOW!
Maintenance/Inspection Information:
Visually inspect
the assist handle and mounting bracket, and check
for loose hardware on a monthly basis. Tighten loose
hardware as stated in the installation instructions.
Warning:
In the event worn or broken part(s) are
identified, remove the device from service until repairs
are made.
Note:
Assist devices are made for right or left side of
bed as viewed from the foot of the bed. The latch on
both sides must face the foot end of the bed.
Warning:
Retaining clips must be inserted
horizontally. Failure to do so could result in
serious injury or death.
Retaining clips are located
on all the rail mounting
brackets. Secure before use.
Retaining Clip
Figure 6
Figure 7
