INSTALLATION
1. Select an appropriate location for the V-T8.
2. Run all the necessary wiring to the V-T8. Label the
wires for future reference.
3. Strip 1/4" of insulation from the end of each wire.
Tightly twist the end of each wire until no frayed
ends remain.
4. Locate the Snap and lock
Connectors and remove
them if they are plugged in.
See Figure 4.
5. Use a small flathead
screwdriver or your thumb
to raise the locking tabs,
exposing the holes on the
connectors.
INSTALLATION DIAGRAM
Stereo Receiver
Speaker
Pair 4
Speaker
Pair 3
Speaker
Pair 2
Speaker
Pair 1
5
Figure 4
V-T8
