jobmate JMCGA18G.9, Инструкция по безопасности и эксплуатации, Страница: 10 / 16

10
CHARGING PROCEDURE
NOTE: Before using the tool, read the instruction book
carefully.
1. CHARGING YOUR BATTERY PACK
A) CHARGING THE BATTERY
The battery charger supplied is matched to the Li-Ion battery
installed in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging.
When the battery is empty, the machine is switched off
by means of a protective circuit: The tool holder no longer
rotates.
In a warm environment or after heavy use, the battery pack
may become too hot to permit charging. Allow time for the
battery to cool down before recharging.
When the battery pack is charged for the first time and after
prolonged storage, the battery pack will accept a 100%
charge after several charge and discharge cycles.
B) TO REMOVE THE BATTERY PACK (SEE FIG. A)
Depress the battery pack release button (5) firmly first and
then slide the battery pack out from your tool.
C) TO INSTALL THE BATTERY PACK (SEE FIG. B)
Slide the fully charged battery pack onto the tool with
sufficient force until it clicks into position.
D) HOW TO CHARGE YOUR BATTERY PACK (SEE FIG C)
BEFORE PUTTING INTO OPERATION
NOTE:
a) Do not use any charger other than that specifically provided for
use with the equipment.
b) If the battery pack is very hot you must remove your battery
pack from the charger and allow time for the battery to cool down
before recharging.
c) The battery in your new tool is not charged when it leaves the
plant. Therefore it must be full charged before using the first time.
d) Please charge the battery to reach full or no less than half
charge before storage. If the tool will not be used for long periods
of time, charge the battery every 3-6 months.
1) Plug the charger into an appropriate outlet
2) Place the battery pack into the charger
3) When charging is completed, unplug the charger and remove the
battery pack
Note: If the battery pack is locked in the charger, press the battery
pack release button and remove it.
Warning: When battery charge runs out after continuous use or
exposure to direct sunlight or heat, allow time for the battery to
cool down before recharging to achieve the full charge.
Fig.B
Fig.A
Fig.C
Fig.D
Fig.E
Fig.F1
Fig.F2
15
0
-30
0
15
0
-30
0
Fig.F3
Fig.H
Fig.G
Fig.I