jobmate JM130MDK, Инструкция по безопасности и эксплуатации, Страница: 9 / 16

9
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book
carefully.
INTENDED USE
The machine is intended for planing of firmly supported
wooden materials, such as beams and boards. It is also
suitable for beveling edges and rebating.
1. CHANGE THE COLLET (SEE FIG. A)
Three size of collets are provided to accommodate the
different accessories shank sizes. When using an accessory
with a smaller or larger shaft, you will need to change the
collet which matches the shank size of the accessory as
follows.
Press the spindle lock button. Loosen the collet nut (1) with
the spanner provided. Remove the collet nut (1) and then fully
insert the appropriate size collet (7) into the spindle. Reinstall
the collet nut (1) by finger tight. Do not over-tighten the nut
when there is no accessory in the collet.
WARNING ! You need make sure full tighten the collet
nut before operation.
Always use the collet which matches the shank size of the
accessory you plan to use. Do not force a larger diameter
shank into a smaller collet.
2. FITTING AN ACCESSORY (SEE FIG. B, C)
Press the spindle lock button. Hold down and rotate the
spindle by hand until the spindle lock engages with the spindle.
Loosen the collet nut anti-clockwise using the spanner if
necessary.
Fully insert the tool shank into the collet. Tighten the collet nut
with the spanner but do not over-tighten. Finally release the
spindle lock button.
WARNING : Do not engage the spindle lock button
while the tool is running.
1 7
11 a
2
1
a
b c d e
29
f
Fig.A
Fig.B
Fig.C
Fig.D
Fig.G3
Fig.G2
Fig.G1
Fig.F2
Fig.F1
Fig.E
Fig.H
Fig.I
Fig.J
Fig.K
Fig.L
Fig.M
Fig.N