10
ASSEMBLY & OPERATION
INSTALLING DUST BAG ASSEMBLY
1. Insert dust duct bag assembly sleeve
(1) into dust chute (2) (see Fig. 1).
NOTE:
Make sure the tabs (3) insert
into the matching slots (4) in the dust
chute.
2. Rotate dust chute sleeve CLOCKWISE
to lock it into place.
REMOVING & CLEANING DUST BAG
1. Remove dust bag assembly by rotating
it COUNTER-CLOCKWISE and pulling
it out of the dust chute.
2. Remove the dust bag (1) from the dust
bag support (2) by opening the
elasticized end of the dust bag (3) and
sliding it off the dust bag support (see
Fig. 2).
3. Carefully shake the dust bag with the
elasticized opening pointing downward
to remove the sanding dust.
NOTE:
It is best to perform this
function outdoors over a trash can to
prevent sanding dust from escaping
into the work area.
4. Once the sanding dust is removed
from the dust bag, reinstall the dust
bag onto the dust bag support.
5. Reinstall the dust bag assembly into
the dust chute as noted above.
INSTALLING SANDPAPER
WARNING:
Unplug the sander
from the power source before installing
or changing sandpaper.
1. Lift up and outward on the front and
rear sandpaper clamp levers (1) at the
front and rear of the backing pad (2)
(see Fig. 3).
2. Insert one end of the 1/4 sheet
sandpaper (3) with grit side up into the
open front sandpaper clamp (4),
making sure it is aligned with the
backing pad. Lift sandpaper clamp
lever up and inward to lock sandpaper
into clamp.
!
Fig. 3
Fig. 2
Fig. 1
