10-2009
Operating under the theory that an ounce of prevention is worth a pound of headaches.
Note that this installation guide is only a guideline. Each boat is different and improvisation is needed to mount your Addict bimini on your tower.
We advise you to have your Bimini mounted by a professional who has experience in boatconstructions and mounting towers.
Contents of Box
Unpack the carton, there will be 13 frame sections and mount set:
Bimini Mount set
Bimini Bars
Prior to assembly, make sure all the required parts are present.
Step 1
Mount the 4 clamps on the tower as pictured. Snug the bolt but do not fully tighten at this time.
This position of the mounts is just a starting position and must be adjusted later for a perfect fit of the bimini.
The clamp should be mounted with the M6 loop on the inside of the boat. Note to use the FL as a front mount on
the left side, RL as rear mount left side, FR as a front mount on the right side, RL as rear mount right side.
Make sure to use the rubber rings to prevent scratching the tower
Step2
Assemble the frame as pictured below:
TIP: You can use Loctite® to prevent the small screws (1) from loosening up during use.
Frequently check/tighten the screws before use.
31CM
87CM
To assemble the (size M) Bimini top
, please use B&D holes.
The with of the Bimini is 137cm measured on the top.
You can make the Bimini top 10cm smaller by using holes C&D.
To assemble the (size L) Bimini top
, please use A&E holes.
The with of the Bimini is 157cm measured on the top.
You can make the Bimini top 10cm smaller by using holes B&E.
Other combinations are not recommended as the Sunbrella® top
will not fit the frame anymore.
picture 1
picture 3
picture 2
To be used on
the addict 1.1
and 1.3 Tower
To be used on the addict
1.5 Tower
Sunbrella® top is available in two sizes
I
II
III
IV
VI
V
41cm
84cm
110cm
A
B
I
II
V or IV
VI
I
II
V or IV
Left side mount
Right side mount
FL
FR
RL
RR
