Jobe Sports E-duna, Руководство пользователя

Страница: 9 / 90

9
CHARGING THE REMOTE CONTROL’S BATTERY
Also charge the remote control’s battery with the included charger in a completely dry environment.
Use the included USB charger to charge the remote control’s battery. Make sure the remote control is completely
dry. The charger comes with a 5V USB adapter, into which you plug the included charging cable.
The charging cable’s other end has a magnetic connector, which you plug into the remote control. Charging will
commence after a few seconds. The remote control will light up.
- red: charging
- green: charging completed
If the LED does not light up in a few seconds, turn the magnetic connector around and connect it in the opposite
position.
Charging is automatic. When the remote is fully charged, disconnect the cable.
The Drive battery and remote control batteries can be charged at the same time. It is recommended that you
charge the remote control’s battery after every session, just like the drive battery.
WARNINGS
- Before charging, read all instructions and warnings.
- Before charging, make sure all the components are dry, clean, and undamaged.
DO NOT charge the batteries if they appear in any way damaged!
- Only charge in a dry environment at room temperature
- DO NOT charge near flammable or volatile substances
- DO NOT cover the battery, remote control, or charger with any material while charging.
- You MUST be present during charging so you can monitor the charging process.
- DO NOT leave the battery or remote control connected to the charger after charging
is complete.
- DO NOT let minors charge the batteries.
- Use ONLY the original, included cables and charger for charging the Drive
and remote control.
- If something goes wrong with charging, immediately stop the process.
CONNECTING THE BATTERY TO THE DRIVE
The connector MUST be properly attached to the battery. Turn the connector around until it slides in easily
(see picture 1). Lightly press the connector and turn the locking ring clockwise until it clicks. Only this way can the
connector ensure a proper, watertight seal.
DO NOT use any tools or other objects when (dis)connecting the connector.
It is extremely important that the battery cover is placed ONLY on perfectly clean surfaces, as any foreign object
(including sand or excessive dust) can damage the watertight seal and allow water to enter the Drive.
This includes the plastic around the edge where the seal on the cover rests on the drive itself. (see picture 2)
Place the drive in the board bag and head off for your first session with your board. The board bag has 2 pockets
on the inside: the charger goes in one, and the fin in the other, and instructions can be kept in either one, however
we recommend keeping it in the dry pocket with the charger, as the fin will likely be wet.
WARNING DO NOT take the charger with you on the water. Leave the charger safely stored in a dry place,
protected from sunlight and away from any source of heat.
1 2 3