Joab EcoDrive LA, Руководство по эксплуатации и обслуживанию

Страница: 34 / 89

Fast Drive System - FDS
Intelligent, stepless, fast drive, ensures that the body is moved backwards (unloading) at
optimal speed, when shunting. The system senses the weight of the body's load and adjusts
the speed accordingly, to guarantee smooth and fast operation.
To activate this function, simply press and hold down the bottom button (the button with a small
raised dot on it) on the control-stick when unloading a body in shunting mode. See also
"Con-
trol Stick Function", on page 17 .
Fast Drive System Plus - FDS+
Fast drive loading with intelligent load sensing. This is in addition to the standard function. See
"Fast Drive System - FDS" .
The system senses whether it is beneficial and safe to activate fast drive load. It checks if the
cylinders have sufficient power gained from the load. If so, the pump is shut off and a controlled
free-lowering is initiated. In addition, Fast Lowering System Plus - FLS+ is also included.
FDS+ allows for a faster shunting operation – 60% faster. This is only applicable to loads that
are less than three ton.
To activate this function, simply press and hold down the bottom button (the button with a small
raised dot on it) on the control-stick, while shunting. The system will then determine if it is pos-
sible to perform fast shunting. If it is possible, shunting will begin, as long as the bottom button
is held down.
Service Online System - SOS
JOAB's Cloud solution for EcoDrive provides remote roadside assistance, regardless of your
location.
Container Memory System - CMS
CMS ensures that the extending-section stops at a preset point when loading a container onto
the hook-lift. The distance that the extending-section can extend is limited. This is used for
applications where a short length container is loaded onto the hooklift. It prevents the wheels of
the container from contacting the hook-lift.
It is possible to save two CMS stop positions. To set a CMS stop position, simply extend the
extending-section so that it is located at the desired position and stop. Tap the desired CMS
icon to activate it, then press and hold down the CMS icon (1 or 2)
for five seconds to set
the stop position.
Before using the CMS in normal operation, operate it and verify that it stops at the
desired position. Make sure it does not exceed expected clearances. If necessary,
reset the stop position until the desired stop position is obtained.
26
Operation | EcoDriveOptional Functions
EcoDrive 2.0 manual: 1021970 Edition 1 | 2022-02-04