JMR electronics 1005, Руководство пользователя, Страница: 3 / 8

4. Be sure to check the level of the hydraulic oil frequently. DO NOT allow the
reservoir to run dry. This will void the warranty.
5. Under normal use, the pivot bushings should be greased every 250-500 cycles.
Under high use conditions it will be necessary to grease the pivot bushings every
month or more often as necessary.
6. Inspect and replace bushing when worn or sloppy.
WARNING
DO NOT attempt use damaged parts in the tubing bender.
For your safety, DO NOT attempt to repair and reuse any damaged bender
parts.
7. Replace any worn, bent, or damaged parts immediately. Replacement parts are
available from JMR Manufacturing or your local dealer.
8. Replace any worn or damaged hydraulics hoses immediately. Replacement hoses
are available from JMR Manufacturing or your local dealer.
9. Replace any worn or damaged Air Hydraulics Pump parts immediately using
only factory authorized parts. Parts are available from JMR Manufacturing or
your local dealer.
10. Dies are available for tubing (measured by outside diameter), or Sched 40 pipe.
Always use the proper size/type of die for the material being worked.
OPERATION OF THE BENDER
WARNING
Because of the precision air return NEVER store or leave the cylinder in the
full extended/open position. If left in the extended position the hydraulic fluid
will drain from the cylinder. When the air supply is reattached the cylinder
could retract uncontrollably and could cause equipment damage and/or sever
personal injuries. Use extreme care when reattaching the air supply to the
bender. Make sure there are no dies, pins, body parts on the bender when
reattaching the air source to the pump.
1. Connect the foot control valve to an air supply, not to exceed 90lbs as shown
in Figure 1.
2. The tubing material should be clean and free from defects.
3. Always grease the die block prior to bending.
4. Make sure that all drive pins are fully seated.
5. Pass tube into die and position as required for start of bend. All bends will
start at the edge of the radius die as shown in Figure 2.
6. Install the U strap and snug retainer bolt if needed.
WARNING
Never put your hands or other body parts into bender apparatus.