Use of the charger:
Connection
1.
Connect the charger’s power cable up to the power socket and the power switch.
2.
Firstly, connect the red clip to the battery’s positive terminal.
3.
Then connect the black clip to either the battery’s negative terminal or the chassis ground.
4.
Select the desired mode (see “Available modes”) and press Start.
5.
When subsequently switching to another mode, interrupt the current mode firstly by pressing Stop.
Disconnection
1.
Once you have finished using the charger, press Stop and disconnect the device from the mains.
2.
Remove the black clip from the negative terminal/chassis ground.
3.
Then remove the red clip from the battery’s positive terminal.
Charging the battery
JMP Skan battery chargers support the charging of all conventional battery types:
standard lead acid; gel; AGM; EFB; lithium (LiFePO4).
1.
Connect the device to the battery/vehicle as previously described.
2.
Select the CHARGE mode using the function key.
3.
Then use Amperage to select the battery capacity and Volt / Batt. to select the battery type.
4.
Use the Start/Stop key to start the supply of electricity.
5.
Use the Start/Stop key to stop the charging process.
The power cable mode “FLASH”
Extensive diagnostic work and “flashing” of vehicle software result in high loading of the battery. In order to
guarantee a safe process which does not damage the battery, the JMP Skan offers a special mode, which
supports the 12 V battery with up to 60 A.
1.
Connect the device to the battery/vehicle as previously described.
2.
Select the FLASH mode using the function key.
3.
Then use Amperage to select the required current and Volt / Batt. to select the desired voltage.
4.
Use the Start/Stop key to start the supply of electricity.
5.
Use the Start/Stop key to stop the supply of electricity.
