4.
IMPORTANT:
Please do not attempt to adjust the end of the brake cable that is located on the underside of the scooter.
Please contact JML customer services if you have any queries.
HOW TO BRAKE
Pulling the brakes sharply at high speed can cause the rear wheel to lock which may result in a “flat spot” on the rear wheel.
To avoid this, pull gently on the brake, this will decrease the chances of skidding and ultimately preventing flat-spotting.
Flat-spotting on the rear wheel will not be covered under guarantee.
The UBER SCOOT S300 has a rear wheel brake-pad system.
To tighten your brakes, loosen the lock nut (A) by turning it anti-clockwise until it spins freely. Now turn the tensioning bolt (B)
outwards until the brake is correctly adjusted. Finally, tighten the lock nut to lock the adjustment in place.
To loosen your brakes, loosen the lock nut (A). Turn the tensioning bolt (B) inward and the brake will loosen. Now tighten the
lock nut to lock the adjustment in place.
ADJUSTING YOUR BRAKES & BRAKING
If your UBER SCOOT S300 happens to suddenly stop working, check the fuse located below the deck on the left-hand side of
the scooter above the charging port. The fuse may have shorted if the motor was overloaded. If so, replace the fuse and correct
the riding conditions that caused the overload. Avoid repeatedly tripping the breaker. Should you experience further issues
please contact JML customer services.
Glass Fuse 40A 250V
FUSE/RESET
B
A
Fuse
