JML Snap Screen, Инструкция по эксплуатации

Страница: 5 / 8

3 4
Door Frame Preparation
1. First you must determine which side of
your door Snap Screen
®
needs to be
fitted to.
• If your door opens inwards,
Snap Screen
®
must be fitted to the
outside of your door frame.
• If your door opens outwards,
Snap Screen
®
must be fitted to the
inside of your door frame.
2. Ensure the surface is completely dry
and free from debris before applying the
fibre fix strips to the frame. To ensure the
surface is clean we recommend using an
alcohol wipe on UPVC and wood frames.
3. Mark the centre of the top of your door
frame.
TIP - Measure the full width at the top of
your door to determine where the centre
is and mark with a piece of tape to ensure
accuracy.
Snap Screen
®
Preparation
1. Position both Snap Screen
®
door panels
on the floor parallel to each other, with
the thick side of the magnets facing
upwards. This side will be attached to
your door frame.
IMPORTANT - When you lie the Snap
Screen
®
panels on the floor, the left Snap
Screen
®
door panel should be positioned
on the right-hand side and the right Snap
Screen
®
door panel should be positioned
on the left-hand side. Please refer to the
diagram on page 5.
2. Allow the magnets to snap together.
3. Identify the top of the Snap Screen
®
.The
top of the Snap Screen
®
can be identified by
the approx. 18cm gap between the top of
the panel and the first magnet. The bottom
can be identified by the decorative frill.
Before Use - Preparation
1. Snap Screen
®
requires 3 fibre fix strips
(labelled A, B, C on the diagram on the
following page) to be positioned at the top
of each panel and a further 3 fibre fix strips
(labelled 1, 2, 3) positioned down each
side.
• Please refer to the diagram on page 5
for fibre fix strip positioning
• It is recommended that you lay the
fibre fix strips in the correct position
before removing the white backing to
ensure correct spacing.
IMPORTANT
Plastic frames - it is recommended that
you use the fibre fix strips only.
Wooden frames - a combination of fibre
fix strips and securing pins (provided) can
be used.
Snap Screen
®
should only be fixed to door
frames, it should not be fixed to normal
wall space as it may cause damage to the
paintwork.
NOTE - The securing pins, if used, will leave
a small hole in the wood. If the fibre fix strips
are used on painted wood, they may cause
a small amount of damage to the paint if
later removed.
2. Once you are happy with the positioning of
the fibre fix strips remove ONE side of the
white backing and stick into place directly
onto the Snap Screen
®
, applying plenty of
pressure.
3. Repeat this process until all the fibre fix
strips are stuck in position.
Snap Screen
®
fibre fix strip positioning