Wireless DMX Control instructions :
Set up wireless DMX
The fixture needs to be paired from the wireless DMX transmitter. Follow below steps to pair.
Step 1
: Connect the DMX512 controller to the wireless DMX transmitter.
Step 2
: Switch on the device , turn on the wireless DMX control on from control panel
‘
rfon
’
Step 3
: Set the device to DMX mode. (AXXX or dXXX)
Step 4
: Switch off the device. Press and hold the
‘
DMX select
’
button whilst switching on the fixture.
Once the fixture turns on the
‘
wireless status
’
light will be lit white and the unit will be in
“setup mode”.
Step 5
: The
‘
wireless indicator
’
will be lit to a specific colour to indicate the protocol being used for
the transmission as shown in TABLE1. Pressing the button will cycle through the colours and once you
want to set the protocol pressing the button for more than 1s will save the protocol. The transmitters,
receivers and transceivers will remember the protocol used even after a power cycle with their built in
memory chip.
Now you need to setup as for WDMX mode or EL mode
Protocols
TABLE1
Using W-DMX mode
Transmitters
Pressing the button momentarily will connect to all unconnected receivers in the coverage area.
Pressing the button for more than 3s will disconnect all receivers in the coverage area.
Receivers
Pressing the button for more than 3s will disconnect the device with a transmitter.
NOTE:
The colour of the light will indicate the group as shown in Table2.
The receiver will not connect with a new transmitter unless it is disconnected first.
Color
Protocol
RED
ELDMX Transmit and receive
GREEN
W-DMX Receive
BLUE
W-DMX G3 Transmit
YELLOW
W-DMX G4 Transmit
PURPLE
GZ Receive * ( * Receiver only)
