RET-200 REPLACEMENT
REV. 010616
1
Note: This is a guide for removing and replacing a RET-200 motor on a JMA antenna.
I.
RET-200 Motor Removal
1.
Remove any attached AISG cable(s) from the motor.
2.
Carefully remove the 4 mounting screws and place them in a safe location.
Ensure that all of the washers stay together with each screw for re-use. See Fig. 1.
3.
Carefully slide the RET-200 out from the antenna.
4.
Ensure that the orange gasket is undamaged. If damaged, contact JMA Tech
support for a replacement gasket. See Fig 1.
JMA Tech Support
Fig. 1 – Mounting Screws and Gasket
Fig. 2 – RET Firmware Rev and Serial Number
Serial #
(UID)
