JLG Toucan 12E, Руководство по эксплуатации и безопасности

Страница: 30 / 136

SECTION 2 – USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
2-8 – JLG Lift – 31210162
ride button must be used for the drive function to
operate.
i. With the machine in transport (stowed) position,
drive the machine on a grade, not to exceed the
rated gradeability and stop to ensure the brakes
hold.
Tilt Sensor Check
Check the tilt indicator light/alarm to ensure proper opera-
tion. Wedge a block (P/N: ST2741 - located in the manual
storage container) to activate the tilt sensor and keep it tilted.
The tilt sensor is located on the chassis behind the right rear
wheel. Refer to Figure 2-2.
1. From the platform console :
• Raise the mast by approximately 1m (3 ft.).
a. Confirm an audible alarm sounds.
b. Verify the tilt indicator (red) blinks.
c. Check that the following functions are affected :
- Drive function disabled.
- Mast/Jib lift-up and swinging movements can be
performed only in creep mode.
Figure 2-2. Tilt Sensor