JLG Skytrak 6036, Инструкция по эксплуатации и безопасности

Страница: 73 / 188

Section 4- Operation
4-7 31211018
Transporting a Load
After engaging the load and resting it against the backrest, tilt the load back to position it
for travel. Travel in accordance with the requirements set forth in Section 1- General
Safety Practices and Section 5- Attachments.
Leveling Procedure
1. Position machine in best location to lift or place load.
2. Apply parking brake and move transmission control lever to NEUTRAL.
3. Observe level indicator to determine whether machine must be leveled prior to
lifting load. Level machine with frame level joystick (see page 3-13) or outrigger
switches (10042 & 10054 only, see page 3-14).
4. Move boom/attachment to 4 ft (1,2 m) off ground.
(AUS—Move boom so forks are no more than 11.8 in (300 mm) above ground
surface.)
Important things to remember:
• Never raise the boom/attachment more than 4 ft (1,2 m) above ground unless
telehandler is level.
(AUS—Never raise the forks more than 11.8 in (300 mm) above ground surface unless
telehandler is level.)
• The combination of frame leveling and load could cause the telehandler to tip over.
OW0540