SECTION 6 - JLG CONTROL SYSTEM
6-48
31215031
Pressing the ESC key
after starting calibration and
before calibration is complete will display the CAL FAILED
message. This will not disturb the prior calibration infor-
mation.
7.
Press ENTER
. The analyzer screen will read:
8.
If the platform is empty, press ENTER
. The screen
will read:
NOTE:
Accessory weight will reset to 0 lbs. each time the machine
is re-calibrated and will need to be re-entered.
NOTE:
The Accessory weight will be temporarily stored in the Con-
trol System until calibration has been completed success-
fully.
Refer to Table 6-8, Accessory Weights. Use the up and
down analyzer keys to enter the accessory weight(s) (in
lbs). When all the accessory weights are entered, press
ENTER
. The screen will read:
LOAD SENSING:
accessory xxxlbs:
Table 6-8. Accessory Weights
Accessory
Weight
SkyWelder (stick welder)
70 lb (32 kg)
SkyWelder Prep
Prep only = 15 lb (7 kg)
Full install = 70 lb (32 kg)
SkyCutter (plasma cutter)
70 lb (32 kg)
SkCutter / SkyWelder Combo
140 lb (64 kg)
Fire Extinguisher
45 lb (20 kg)
Overhead SoftTouch
80 lb (36 kg)
Work Surface
20 lb (9 kg)
NOTE:
Not all Accessories are available on every JLG model.
Some Accessory combinations are prohibited due to
excessive weight and/or load restriction. If any installed
JLG Accessories are labeled with weight decals but are
not listed in the table above, include their weight when
entering the ACC WEIGHT value.
Go
to
Discount-Equipment.com
to
order
your
parts
