CROSSOVER NETWORK
INSTALLATION:
The crossover networks supplied with your
XR525CXi System should be installed in a dry
location of your vehicle.
DO NOT INSTALL
CROSSOVERS INSIDE OF A DOOR!
Doors often get wet on the inside, which can
damage your crossover networks and could
potentially damage your entire sound system.
The crossovers can be screwed into a solid
surface via two holes located under the protective
cover of the case. To access these holes, simply
squeeze the sides of the cover while gently pulling
the cover away from the base. Make sure that your
mounting location will not cause damage to wiring,
fuel lines, brake lines or any other vital component
of your vehicle. Once you have screwed the case in,
snap the protective cover back into place.
If screwing the crossovers networks in is not
possible, you can also run the supplied nylon wire
ties through the mounting holes to attach the
crossovers to a structure in your car. To do so, take
the covers off, attach the wire ties, and then snap
the covers back into place, lining the wire ties up
with the slots on the sides of the protective cover.
Make sure that you do not attach the crossovers to
a moving part or to any part that may interfere with
pedal operation, gear shift operation, steering, or
airbag deployment.
For crossover network wiring instructions,
refer to the diagram on pages 2 & 3 of this manual.
6
JL AUDIO
XR525-CXi
