Continued on Next Page
SB-H-PLT/10TW3 INSTR_SKU# 011365
S T E P 1 2
Measure and mark 1” to the left of the tape.
S T E P 1 6
Pictured is the front of the plastic tray with the section
removed and the hardware installed.
S T E P 1 1
Remove the Stealthbox® from the tray.
Pictured is the section of the plastic tray that needs to be cut.
Use the dimensions given in
Steps 12-14
to mark the tray
as shown.
S T E P 1 5
Place the Stealthbox® back into position inside the plastic
tray.
Slide a 1/4” Lock Washer and a 1/4” Flat Washer over each of
the 1/4 - 20 x 1” Bolt, and thread an assembly through each
of the holes drilled in the plastic tray and into the inserts in
the enclosure. Pictured is the rear of the plastic tray with the
hardware installed.
S T E P 1 0
Place the Stealthbox® into position in the driver’s side of the
plastic tray, and apply a piece of tape on the front side of the
tray to mark the edge of the enclosure.
S T E P 1 4
Measure and mark 5-1/2” from the driver’s side.
Cut out the section of the plastic tray shown in
Step 11
.
S T E P 9
Pictured is the location of the pilot hole.
Enlarge all three holes to 3/8”.
S T E P 1 3
Measure and mark 3-1/2” from the top of the tray.
Page 4 • JL Audio, Inc., 2016
