Page 4 • JL Audio, Inc., 2019
Continued on Next Page
S T E P 8
Align the large hole in the Large Bracket with
the center factory seat bolt hole. Be sure the
alignment pin passes through the small hole in
the Large Bracket.
S T E P 7
Carefully lower the enclosure into position,
allowing the Small Bracket to fit over the outer
seat bracket. Align the hole in the Small Bracket
with the factory seat bolt hole.
S T E P 6
Place the Stealthbox® in the vehicle.
Connect speaker cable to the terminal cup on
the bottom of the enclosure.
S T E P 5
Align the Small Bracket to the back of the
driver’s side of the enclosure as shown. Slide a
3/8” Split Lock Washer and a 3/8” Flat Washer
over each of two 3/8 - 16 x 1-1/2” Hex Head
Bolts, pass an assembly through each slot in
the Small Bracket, into the threaded inserts on
the back of the enclosure, and hand tighten.
Repeat the process for the Large Bracket on the
opposite side.
S T E P 4
Remove the center seat bolt and seat belt
bracket.
S T E P 3
Remove the outer seat bolt on the driver’s side.
S T E P 2
Fold the seat bottoms up.
S T E P 1
Empty the rear seat area.
SB-GM-SLVD4/10TW3 INSTR_SKU# 011537
