Continued on Next Page
SB-GM-AVAL_INSTR_SKU#011017
SB-GM-AVAL_INSTR_SKU#011017
S T E P 8
Place a supplied phillip head screw into each pass-through
opening of the factory strike latch.
S T E P 7
With a T-30 Torx socket, remove the pair of strike latches from
the top of the mid-gate.
Each factory bolt has a spacer. Keep these factory spacers for
use in later steps.
S T E P 5
Remove the mid-gate out of the truck.
S T E P 4
With an 13mm deep socket, remove the pair of nuts that
secure each hinge to the floor.
Pull both hinges out of the truck.
Page 2 • JL Audio, Inc 2006
S T E P 1 0
From inside the truck, prop the hinged flaps that are laying
on the rear seats. Use the pull out loop tie down that are
located in the side-wall of the bed to hold these flaps up.
S T E P 1 2
Place a supplied flat washer onto each supplied hex cap
bolt. Use these bolt asseblies to mount the facotry hinges to
the Stealthbox
®
.
S T E P 1 1
With help from a second person, posistion the Stealthbox
®
into mid-gate area. Allow the strike latches to enter the
crossbar. Make sure that the Stealthbox
®
fits flush against
the rear wall.
S T E P 9
Place the facotry spacers from STEP 7 between the strike
latch and the Stealthbox
®
. Secure the factory strike latches
to the top of the Stealthbox
®
.
