JL Audio M200/2, Руководство пользователя

Страница: 6 / 20

6 | JL Audio - XD200/2 Owner’s Manual
TURN-ON LEAD
The M200/2 uses a conven12V remote
turn-on lead, typically controlled by the source
unit's remote turn-on output. The amplifier will
turn on when +12V is present at its “Remote”
input and turn off when +12V is switched off. If
a source unit does not have a dedicated remote
turn-on output, the amplifier’s turn-on lead can
be connected to +12V via a switch that derives
power from an ignition-switched circuit.
The M200/2’s “Remote” turn-on connector is
designed to accept 18 AWG – 12 AWG wire. To
connect the remote turn-on wire to the amplifier,
first back out the set screw on the top of the
terminal block, using the supplied 2.5mm hex
wrench. Strip 1/2 inch (12mm) of wire and insert
the bare wire into the terminal block, seating it
firmly so that no bare wire is exposed. While
holding the wire in the terminal, tighten the set
screw firmly, taking care not to strip the head of
the screw and making sure that the wire (not the
insulation) is firmly gripped by the set screw.
INPUT SECTION
The M200/2’s input section allows you
to send signals to the amplifier section
through the use of two differential inputs.
Input connections are via up to one pair of
traditional RCA-type jacks.
Input Voltage Range:
The M200/2’s input sections are designed to
accept signal voltages from 100mV – 4V. This
will accommodate all preamp level signals and
many speaker level signals.
To use speaker-level sources, simply splice
the speaker output wires of the source unit
onto a pair of RCA plugs. (or use JL Audio part
XD-CLRAIC2-SW) No “line output converter” is
needed in most cases.
If you find that the output cannot be reduced
sufficiently with a direct speaker level signal
applied to the amplifier, you may use a “line
output converter” to reduce the signal level.