JL Audio Fathom IWS, Руководство по установке

Страница: 14 / 20

| Fathom IWS Page 14
Mounting the Wallboard Template
The wallboard template is used to
temporarily secure the enclosure in
the wall cavity while also providing
a hard edge for the surrounding
wallboard installation. The wallboard
template is pre-attached to the
enclosure and must remain attached
until the surrounding wallboard
has been installed and the grille and
subwoofer are ready to be mounted.
Visually center the step at the rear
of the wallboard template to the inside
edges of the left and right wall studs,
(Figure 16)
making sure you have the
same amount of clearance on either
side. Secure the wallboard template
in position using eight #8 x 1.25-inch
screws.
(Figure 17)
Wiring the Enclosure
The final step before the wallboard
installation is to route the speaker cable
down to the enclosure. Feed the speaker
cable through the previously drilled
holes (Figures 18 & 19) in the wooden
cross-member or through an adjacent
stud. Remove the outer jacketing to
expose the individual wires.
(Figures
20 & 21)
Although the hanging rod is
padded to reduce vibrations, the wire
jacketing should remain in place as
far down the hanging rod as possible.
Secure the jacketed portion to the
rod using the supplied wire/cable ties.
(Figure 22)
Observing correct polarity,
remove the insulation from the
individual wires and connect to the
push terminals located on top of
the enclosure.
(Figure 23)
To reduce
the chances of noise and vibration,
position the individual wires
(Figure
24)
so they do not come into contact
with any surrounding parts (enclosure,
mounting brackets, studs, wallboard
surfaces or any other surfaces within
the wall cavity). Any possible contact
point may lead to undesirable rattles
or buzzing, which will be inaccessible
once the surrounding wallboard has
been installed.
Figure 16 Figure 17
Figure 18 Figure 19
Figure 20 Figure 21
Figure 22 Figure 23
Figure 24