10W7AE Subwoofer:
Amplifier Recommendations.
XD600/1 (shown) or 500/1v2
RECOMMENDED CONTINUOUS (RMS) POWER RANGE FOR ONE SUBWOOFER DRIVER:
5 0 0 W
7 5 0 W
1 0 0 0 W
2 0 0 0 W
4 0 0 0 W
2 5 0 W
10W7AE
10W7AE-3
Free Air Resonance (Fs): 30.6 Hz
Electrical “Q” (Qes): 0.578
Mechanical “Q” (Qms): 7.647
Total Speaker “Q” (Qts): 0.537
Equivalent Compliance (Vas): 1.28 cu. ft. (36.1 ltrs)
One-Way, Linear Excursion (Xmax)*: 0.9 in. (23 mm)
Thermal Power Handling (Pt): 750 Watts Continuous
Reference Efficiency (no): 0.171 %
Efficiency (SPL @ 1W/1m): 84.3 dB
DC Resistance (Re): 2.75Ω
Effective Piston Area (Sd): 59.8 sq. in. (0.0386 sq. m)
Nominal Impedance (Znom): 3Ω
* Xmax specifications are derived via one-way voice coil
overhang method with no correction factors applied.
Remote Level Control
Requires HD-RLC controller (sold separately).
Multiple amplifiers can be controlled with
one controller by adding standard phone
cable splitter (not included). This is a true
subwoofer level control, not a “bass boost”.
Input Sensitivity Controls:
Proper adjustment of these
controls is critical!
See “Input Sensitivity Setting
Guide” on pg. 14 for precise
setting instructions.
JL Audio XD600/1:
These settings are intended as a
“baseline” for tuning your system.
Depending on your vehicle and
your preferences, some variation
in the crossover and bass control
settings may be necessary for
optimum performance.
= position of knob
= position of switch
= switch with two possible positions
= setting will vary (see sidebar)
Filter Mode & Slope:
Set “LP Filter Mode/ Slope” switch
to “24dB”. Set “Filter Freq. (Hz)”
knob to “85”. Lower settings are
likely to result in a poor transition
between the upper response of the
W7AE and the lower response of
the mid-bass speakers.
10
