9
①
②
2.Signal connection of transmitter and receiver
①.Turn on the drone and place it on a level surface,
the indicator light of transmitter and the LED of drone
flashing.
②.Push the throttle joystick to the highest point then push
back to the lowest point,and when you hear two beeps,
the indicator light of transmitter and the LED of drone
become normally on,the signal connection has
completed.
3.Transmitter calibration
Apply transmitter calibration when the drone fails to take
off vertically.Push two joysticks at the same time to the
lower left corner together. When the lights of drone are
on and then start flashing and keep on again, the
calibration is complete. The drone must be placed on a
horizontal surface in a steady state when the calibration
is conducted.
