- 4
-
Do not remove any part installed by Jinko Solar or disassemble the module.
All instructions should be read and understood before attempting to install, wire,
operate and maintain the module.
Please don‟t
lift up PV modules using the attached cables or the junction box.
All PV systems must be earthed. If there is no special regulation, please follow
the National Electrical Code or other national code.
Under normal conditions, a photovoltaic module is likely to experience conditions
that produce more current and/or voltage than reported at standard test
conditions. Accordingly, the value of Isc and Voc marked on this module should
be multiplied by 1.25 when determining PV system component voltage ratings,
conductor current ratings, fuse sizes, and size of controls connected to the PV
output.
Once the PV module has been shipped to the installation site, all of the parts
should be unpacked properly with care.
Do not stand or step on the PV module like below pictures show, this is prohibited
and there can be risks of micro-crack which may cause a sharp decline of
module‟s power
performance; what‟s
more, it may threat your safety.
Only PV modules with the same cell size should be connected in series.
During all transportation situations, please make sure no huge shock for the
vehicle or the modules, as this may damage the module or lead the cell to be
crack.
During all transportation situation, never let the module fall down from the vehicle,
house or hands. This will break the cells of the modules.
Do not clean the glass with chemicals.
Do not disconnect any of the modules when it is under load.
