background image

I

In

ns

st

tr

ru

uc

ct

ti

io

on

n S

Sh

he

ee

et

t F

Fo

or

r T

To

oo

ol

l #

#1

17

77

76

6

Rev N/C

5/05

No.1776-IS

555 Dawson Drive, Camarillo, CA 93012    Phone 805-482-6913 • Fax 805-482-7422

CAUTION:   Wear safety glasses. Excessive force may damage parts! See JIMS

®

catalog  for over 100 other top quality professional tools. the last tool you

will ever need to buy!

4. Place the fork slider over the post at the bottom of the Fork 

Compressor Tool and into the top of the Fork Compressor Tool 
so that the FL adapter or the damper assembly lines up with the  
locator and 2 allen screws (See 

Fig. 1

). Snug the 2 allen screws 

so the tip of each screw has engaged into each of the detents.

NOTE:

Turning the top adjuster nut of the Fork Compressor Tool

clockwise will shorten the fork spring. Turning the top nut of the Fork
Compressor Tool counter-clockwise will lengthen the fork spring.

WARNING! 

Never use an impact wrench on the Fork Compressor

Tool. Doing so could cause damage to the tool and/or bodily injury
to you.

5. Turn the top adjuster nut of the Fork Compressor Tool clockwise  

with the 3/4” socket and ratchet. Only compress spring enough 
to release tension from the locknut. With a 14mm deep socket, 
remove lock nut from the damper rod.

6. Turn the top adjuster nut of the Fork Compressor Tool counter-clock

wise with the 3/4” socket and ratchet to release tension on the 

fork spring. Remove fork assembly from the Fork Compressor Tool. 

For Assembly:

Follow these instructions in reverse for assembly. Be sure 

to follow all guidelines as stated in dis-assembly. 

NOTE: 

In some cases the damper rod will fall inside the fork tube

assembly where it does not stick-up past the damper or FL adapter.
In this situation, slide the damper rod extension JIMS

® 

(No. 1776-9)

through the FL adapter or damper assembly and thread it onto the
end of the damper rod. Pull the damper rod out of the tube assem-
bly and unscrew the rod extension. Do not allow the damper rod to
retract back inside the tube assembly. From there, thread the lock
nut onto the end of the damper rod and continue to follow the
instructions in reverse order.

Again, JIMS

®

is not responsible for damage, injury or your work!

Please follow these instructions carefully and you will have a safe

and productive experience.

FIGURE 2

FIGURE 3

2

Отзывы: