2013
4
5
PSS-14-GB
www.jilong.com
PSS-14-GB
www.jilong.com
Step 1:
(1) Unlock the Handle Lock from the Trap Body (P01)
as indicated.
(2) Insert and lock the Align Handle (P02) to the Trap
Body (P01) at the desired position.
Step 5:
Place the Skimmer Strainer (P06), which has already
assembled with Skimmer Top (P07), into the Trap
Body (P01). Gently push downwards and immerse the
Skimmer Strainer (P06) until it is well in place.
Step 2:
(1) Connect one end of the Skimmer Hose (P11) to the
bottom of the Trap Body (P01).
(2) Connect the other end of the Skimmer Hose (P11)
to the Hose Adaptor (P04) as shown.
Note:
Ensure the Strainer Top (P07) is floating parallel
against the water surface at all time and should be
floating perpendicularly off the Trap Body (P01). Adjust
the surface skimmer position if necessary.
Step 4:
Secure the Skimmer Hose (P11+P04) properly to the
water outlet and adjust the height of the Trap Body
(P01) to a 2 cm lower than the water level.
Step 7:
Connect the filter pump to an electrical outlet, and it is
set to work. Enjoy !
Step 3:
(1) Place the assembled unit over the top of an
inflatable pool top ring near the water outlet (that is,
the lower hose connection to the filter pump’s inlet).
(2) Assemble the hook unit as shown -- press and
slide the Clutch Handle (P03) into the Align Handle
(P02), then adjust the handle unit to be snug around
the inflatable ring. Make sure the handle is securely
tightened over the pool.
Step 6:
Lastly, refer to the filter pump system picture as
shown. You can now start setting up the Filter Pump
by following the owner’s manual.
Assembly for inflatable pools with inflatable top rings
Note: if you are using METAL FRAME POOL, GO TO PAGE 6
