Jigsaw provide the solution piece by piece
Feel the Future of Heating. Step out of the Shade and into the Sun
8
9
INSTALLATION ADVICE
MOUNTING
•
Should not be installed in contact with the floor.
•
The equipment must not be located immediately below a
socket-outlet.
•
The equipment shall not be used if the glass is damaged.
•
If the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.
•
Should not be installed in close proximity to flammable or
combustible materials or pressurised containers.
•
Make sure that there are no electrical cables or pipes in the wall
which could be damaged during installation.
Make sure the plugs and screws provided are suitable for the wall type
onto which the appliance is going to be mounted.
The brackets on the Aluminium heaters are suitable for wall and
ceiling mounting. If in doubt, ask professional qualified personnel.
The heater bracket provides the option of hanging your heater in either
landscape or portrait. Remove the bracket, rotate and refix to suit.
The wall bracket (A) is attached to the wall/ceiling on 4 corners. This
must be done at a suitable height and position with the correct fixings
for the construction of wall.
15mm M5 penny washers should be used
to add the wall fixing. All screw points must be used
The panel bracket (B), attached to the heater, can then be slid into the
wall bracket (A). The retaining grub screw can then be tightened.
400w heaters - One hanging bracket must be used per installation
800w and above - Two hanging brackets must be used per
installation
Wall Bracket (A)
Mating Wall & Panel Bracket (B)
Joined Brackets (C)
Mounting (Advised)
1.5m to middle of heater from floor
0.50m to any surrounding objects
0.20cm to any wall or ceiling (Minimum)
0.20cm to any electrical socket (Minimum)
Avoid blocking with any items, clothing
or furniture
