Pre-Use Procedure
Before using your Jiffy Power Ice Drill to drill holes in ice,
follow this procedure to prepare for proper and correct
use.
Carefully examine your Jiffy Power Ice Drill for
hidden shipping damage. If any external damage
is observed to the Jiffy Power Ice Drill, contact
Feldmann Engineering.
Find, read and understand your Jiffy operators
manual. Contact your Jiffy dealer or Feldmann
Engineering if you do not understand any of the
instructions in this manual.
Assemble the components of your Jiffy Power Ice
Drill as indicated in the Assembly of Drill section
of this manual. Leave the Jiffy Blade Protector on
the drill assembly and make certain it is securely
fastened.
DO NOT RETURN your Jiffy Lectric Drill TO THE
RETAILER THAT SOLD IT TO YOU. THEY ARE NOT
AUTHORIZED TO PROVIDE REPAIRS OR WARRANTY
REPLACEMENT unless they are an authorized Jiffy
warranty station. If you have any questions concerning
the authorization of a service station, contact Feldmann
Engineering.
Assembly
For units with “New” Jiffy E-Z Connect™ Collar
Connect drill assembly to powerhead by sliding E-Z
Connect™ Collar down and pulling clevis pin out.
Then slide drill assembly onto output shaft. Reinsert
clevis pin through drill assembly and output shaft,
then slide E-Z Connect™ Collar up to lock pin in
place.
Note: Do not remove clevis pin from collar tether.
BATTERY INFORMATION –
The JIFFY LECTRIC requires a 12 volt, deep cycle,
Car/Truck/Marine or RV battery with a minimum of
650
Cold Cranking Amps.
The power source should be chosen carefully. The
battery directly affects the performance of the drill.
A battery that is too small or in poor condition will
reduce power and cycle time.
The battery should be
fully charged
before every
use. This will ensure maximum performance from
both your JIFFY LECTRIC power ice drill and the
battery.
Instructions for attachment to the battery:
Polarity Identification:
Black Clamp is Negative (-)
Red Clamp is Positive (+)
1. Connect Positive (+) Red Clamp to Positive
(+) Terminal of battery.
2.
Connect Negative (-) Black Clamp to
Negative (-) Terminal of battery.
3. Plug the Red Connector on the long Cable
into the Red Connector on the Powerhead
cable.
4. Before operating the JIFFY LECTRIC read
and understand all instructions in this
manual.
5.
NOTE: If the drill turns in a clockwise
direction you have the battery clamps
connected improperly. Reconnect them to
the opposite battery terminals.
REPLACEMENT TEETH –
Improper cutting may be due to dull or damaged
drill teeth or drill point. Maintain sharp blade teeth
and point. Preserve the original factory cutting
angles when sharpening your drill. File blade teeth
and use a disk sander to sharpen the point. For
professional service see your Jiffy service center.
Only genuine Jiffy blade teeth are to be used.
BLADE TEETH REPLACEMENT
INSTRUCTIONS -
When replacing blade teeth, the beveled edge of
teeth and the head of the capscrews should face
the ice. The stamped part number on the teeth
should face away from the ice, as shown in the
diagram. Use two 7/16” wrenches to remove the
capscrews and to retighten after replacement.
CAUTION –
THE BLADE TEETH ARE SHARP
AND SHOULD BE HANDLED CAREFULLY TO
AVOID FLESH CUTS OR INJURY.
3
