Jiffy Steamer Esteam J-Series, Руководство пользователя

Страница: 21 / 42

21
Jiffy ® J-2000 Wiring Instructions
1. Insert cordset into housing and connect white neutral wire from cordset
bundle to terminal number 5 on the switch.
2. Connect blue wire from the right side of heating element to the right side
of the L-290 thermostat.
3. Insert brass heating unit into housing and tighten with 2 mounting screws.
Connect green ground wire (from cordset) to the nearer of the two mount-
ing screws.
4. Connect black positive wire from cordset to plastic connector on orange
fusible link wire.
5. Connect other end of orange fusible link to terminal number 2
on the switch.
6. Connect yellow wire from the left side of the thermostat to terminal
number 3 on the switch.
7. Connect white wire from the left side of the heater unit to terminal
number 6 on switch.
8. Insert one end of copper water line and compression ring into threaded
fitting at bottom of brass heating unit and tighten nut with a
5/
8
" wrench.
9. Connect other end of water line with compression ring to 90 degree brass
elbow at bottom of water cup and tighten with a
5/
8
" wrench. (Heating unit
may be loosened and adjusted for a better fit if necessary.)
10. Set steamer upright and place black plastic strain relief approximately
4 1/
2
" from end of cord and insert into housing using pliers.
11. Secure bottom plate with four screws.
12. To avoid leakage, be sure and tighten hose (or hat nozzle) with wrench
before using steamer.
Please note switch terminal numbers 2, 3, 5 and 6 indicated on
the enlarged switch diagram are marked on the actual switch.
Jiffy
®
Steamers manufactured before May 2000 are not
marked with the terminal switch numbers, but the terminal
blades are in the same location.