Jidé s.a. – Rue des Meuneries 11 – B-4650 HERVE (Belgique) – Tél. +32 87 31.75.12 – Fax +32 87 31.75.11 –
LOFT (EN) September 2019
15
Fitting of the finishing frame (option)
The fireplace must protrude by 10 mm with respect to the plane of the masonry to enable
the correct attachment of the frame.
A four-sided frame is available as an option.
The finishing frame clips onto the appliance with spring supports
.
1
Place the frame on the appliance, with the back of
the frame inside the fireplace
2
The clips are located outside the body
Assembly and adjustment of baffles
The baffle (lower smoke deflector) is not adjustable, it rests on supports with stops. To
remove it, lift it on one side so that it can be passed over the stops so that it can be lowered
at an angle into the combustion chamber.
The upper baffle, stainless steel, is adjustable, it is mounted originally with the largest
opening. In case of too much draft, you can change the position of the baffle to reduce the
suction effect of the chimney. To do this, it is possible to adjust the position (3 positions) of
the upper baffle. The more you go down the chicane the more you restrict the passage of
fumes. To remove it must be down on its supports at the lowest and then shift to one side to
clear the other side of the support and then out at an angle.
Warning: Care must be taken not to create a backflow by excessively reducing the passage
of fumes.
WARNING: We could not be held responsible for an improper installation. These
must be very neat and made according to standards. Complementary products
used for the installation must be conform to local regulations.
Cleaning
– Chimney sweeping
APPLIANCE MAINTENANCE
