5
sTarT OF Car enGIne FrOM eXTernal sTarTer
Make sure that the ignition key is in “OFF” position (OFF). When using
a starter for cars fitted with an intelligent start button (engine is started
with a button), prior to starting make sure that a car is completely shut
down.
Determine positive and negative accumulator terminals of a car. As usual,
positive terminal is marked with (+) symbol and/or colored in red.
1.
Before connecting terminals to “JIC” device one should thoroughly
connect red clamp to positive (+) accumulator terminal and black clamp
- to its negative (-) terminal.
Make sure that clamps are in MAXIMUM contact with both accumulator
terminals. Terminal connection should be of as high quality as possible;
bad or low-quality connection will not enable starting.
2.
Make sure that “JIC” device is off. Thoroughly insert connector in the
“JIC” device. Check the security of connection between terminals and
clamps as well as between connector and “JIC” device. Check state of
indicators on the connector:
a. IF RED INDICATOR LIGHTS AND AUDIO SIGNAL IS HEARD: con-
nection of connectors to terminals is confused. Read item 1
over again and perform actions described in it. DO NOT PRESS
“BOOST” BUTTON (START)!
b. IF GREEN INDICATOR LIGHTS: accumulator is quite serviceable. DO
NOT PRESS “BOOST” BUTTON (START)! Try to start the engine.
c. IF GREEN INDICATOR LIGHTS AND AUDIO SIGNAL IS HEARD:
accumulator is discharged and cannot be used. Press “BOOST”
BUTTON (START), wait when the green indicator and within
30 seconds start the engine.
d. IF NONE INDICATOR LIGHTS: low quality of electrical connection
or accumulator is heavy discharged. Check all connections. If
there is still no indication, press “BOOST” BUTTON (START).
Position “JIC” device at safe location to prevent from its falling when
engine starting.
3.
Activate “JIC” device.
4.
Start engine of a car.
a. If engine is not started within 3 seconds, one should move ignition
key in “OFF” position (OFF).
b. Disconnect “JIC” device from the connector. Wait for 60 seconds
and repeat steps 1-4 over again. If the problem still exists, go to
chapter “Troubleshooting” of the User’s Manual for “JIC” device to
determine other possible causes of its occurrence.
After successful start of the car engine one should immediately discon-
nect “JIC” device from a connector.
5.
Disconnect clamps from accumulator terminals: at first black clamp
(-), then red clamp (+).
Now the car is ready for operation. Before shutting down the engine, let
it work not less than 15 minutes.
do not make more than 3 attempts to start, it may cause damage to the
starting device.
1
2
3
4
4b
first (+)
first (-)
then (-)
ON (to switch on)
then (+)
Start
BOOST
5