JIASHAN SUPERPOWER TOOLS SMA700, Руководство по сборке и инструкция

Страница: 12 / 18

- 12 -
The figures quoted are emission levels and are not necessarily safe working levels. Whilst
there is a correlation between the emission and exposure levels, this cannot be used reliably to
determine whether or not further precautions are required. Factors that influence the actual level
of exposure of the workforce include the characteristics of the work room, the other sources of
noise etc. i.e. the number of machines and other adjacent processes. Also the permissible
exposure level can vary from country to country. This information, however, will enable the user
of the machine to make a better evaluation of the hazard and risk
1. For moving bearing should be added the lubricating oil regularly to reduce abrading.
2. After long time work, belt maybe relaxant, need to adjust tensioner screw to make belt tight.
3. Tensioner screw maybe rusted after long time, that causes adjust the engine difficultly, always
keep a little lubricating oil on the tensioner screw.
4. When find the blade is not in middle of trough of work table, need to adjust the work table.
1. The tooth blunt or damaged, makes wood section is rough, need to change a new circular saw
blade.
2. Bearing temperature too high will case machine problem, pay special attention to bearing
temperature and noise of bearing parts, if find anomaly to add lubricating oil.
NOISE STATEMENT
ATTENTION IN WHOLE LIFE CYCLE
COMMON FAILURE