BR1 User Manual
10
M-BR1-001-01
5
OPERATION
Before the BR1 meter can be used to make a measurement, the user must setup the meter and connect
and reference a “test jumper” to the front panel.
Powering Up the Meter
To power up the meter:
1.
Verify that the power switch is set to the
“off” position (O). Connect the meter to an AC power
supply using the power cord provided.
2.
Toggle the power switch to the “on” position (I). The JGR logo will flash on
the screen during the
unit’s initialization.
3.
Allow for a warm-up period of up to 30 minutes to obtain an accurate reading.
Device Information and Settings
Swipe left to access the
Setup
page (Figure 4). This page will display information about the unit, its
connectivity status and test settings. See Table 4 for a detailed description.
Figure 4: BR1
Setup
page
