JFA Electronicos J4 Pro, Руководство пользователя

Страница: 4 / 16

IMPORTANT RECOMMENDATIONS:
A The recommended wiring gauge is 1.5mm² for the positive-negative wires and 0.50mm² for
the wires of the remote. The J4 Pro Processor must be attached to a stable base and easily
accessible, away from heat sources. It is not recommended to install the product on the sides of
the speakers due to vibration. Do not attach directly to the bodywork of the vehicle.
Never feed the J4 Pro Processor from the vehicle's original wiring. To avoid noise pickup, use
shielded signal cables. These can not be passed together with the power cables and should be
as short as possible. Observe the cable crossing points. Sharp edges of the bodywork or sharp
corners can cut them, causing future problems.
The J4 Pro Processor must be connected before the ampliers. Failure to do so may result in
damage to the speakers. For the purpose of safe operation of the ampliers, the J4 Pro processor
has a REMOTE OUT output, which sends the + 12V signal after the crossover is activated.
CONNECTION DIAGRAM
IMPORTANT: Any connection of the power, input or output connectors should only be
made with the appliance switched off.
Connect on
RCA output
main
player
Connect the power cables according to the diagram below.
Check out the example of how the outputs can be congured, remembering that the outputs can
be congured in other ways.
Connect on
remote input
two ampliers
Connect on
remote output
player
Amplier
1
Output 1
Amplier
2
Output 2
Amplier
3
Output 3
Amplier
4
Output 4
Adjust level
input