General for A + B
Permanent Installation (fixed)
The heater can be installed horizontally or at a
downward gradient of 15°.
1. The fixings are attached to the housing by
use of 4 screws. The two spacing washers are
placed between the housing and tubular frame
(in the bottom hole).
2. Mark the hole positions. Drill out 4 holes to
attach the fixing to the wall. Use M8 screws.
3. Now fix the heater in the top screws and
attach the bottom screws.
Use of DELTA - List of signs
Off
Fan on
Half fan and half heat
Full fan and half heat
Full fan and full heat
DELTA fan heaters require no maintenance.
However, it is recommended to clean the fan
heater of dust by means of compressed air
after long time of use or after use in dusty
rooms.
Timer
To set time delay rotate the knob clockwise
and then turn back anticlockwise to required
setting.
Electrical Installation
Installation must be carried out with a
multipoled contact breaker with a contact
space measuring at least 3 mm per pole. Per-
manent installation must always be performed
by an authorised electrician in accordance
with current regulations. Only the electrician
has knowledge of current regulations. The
terminals are accessible if the screws and the
plate on the right side are removed.
Preservation and storage
The units must be stored under the following
conditions:
•
relative humidity < = 60%
•
temperature > = 15°C
Disposal Instruction
Equipment containing electrical components
may not be disposed of with household waste.
It must be collected separately alon with other
electrical or electronic waste, as required by
local law.
Fan Heaters
