11
NOTE!
Make sure the total installed memory does not exceeds 3.0GB, otherwise the
system may hang during startup.
Generally, installing DDR SDRAM modules to your motherboard is very easy, you can
refer to figure 2-4 to see what a 184-Pin PC1600/PC2100/PC2700 DDR SDRAM module
looks like.
DDR
2 (
BANK2+
BANK3)
DDR
1 (
BANK0+
BANK1)
DDR
3 (
BANK4+
BANK5)
NOTE!
When you install DIMM module fully into the DIMM socket the eject tab
should be locked into the DIMM module very firmly and fit into its
indention on both sides.
WARNING!
For the DDR SDRAM CLOCK is set at 166MHz, use only PC2700-
compliant DDR Modules. When this motherboard operate at 133Mhz,
most system will not even boot if non-compliant modules are used because
of the strict timing issues, if your DDR Modules are not PC2100-
compliant, set the DDR SDRAM clock to 100MHz to ensure system
stability.
2-5 Expansion Cards
WARNING!
Turn off your power when adding or removing expansion cards or other
system components. Failure to do so may cause severe damage to both
your motherboard and expansion cards.
2-5-1 Procedure For Expansion Card Installation
1. Read the documentation for your expansion card and make any necessary hardware or
software setting for your expansion card such as jumpers.
2. Remove your computer’s cover and the bracket plate on the slot you intend to use.
3. Align the card’s connectors and press firmly.
4. Secure the card on the slot with the screen you remove above.
5. Replace the computer system’s cover.
6. Set up the BIOS if necessary.
7. Install the necessary software driver for your expansion card.
Figure 2-4
