10
2-4 Install Memory
This motherboard provides
two
184-pin DUAL INLINE MEMORY MODULES (DIMM)
sites for memory expansion available from minimum memory size of 64MB to maximum
memory size of 2.0GB DDR SDRAM.
Valid Memory Configurations
Bank
184-Pin DIMM
PCS
Total Memory
Bank 0, 1 (DDR1) DDR200/DDR266/DDR333
DDR SDRAM Module
1
64MB
∼
1.0GB
Bank 2, 3 (DDR2)
DDR200/DDR266
/
DDR333
DDR SDRAM Module
1
64MB
∼
1.0GB
Total
System Memory (Max. 2.0GB)
2
64MB
∼
2.0GB
NOTE!
Make sure the installed memory are DDR266 SDRAM support 133MHz
memory clock, otherwise the system may hang during startup.
Generally, installing DDR SDRAM modules to your motherboard is very easy, you can refer
to figure 2-4 to see what a 184-Pin DDR200/DDR266 DDR SDRAM module looks like.
DDR
2 (
BAN
K2
+
BANK3
)
DDR
1 (
BAN
K0
+
BANK1
)
NOTE!
When you install DIMM module fully into the DIMM socket the eject tab should
be locked into the DIMM module very firmly and fit into its indention on both
sides.
WARNING!
For the DDR SDRAM CLOCK is set at 133MHz, use only DDR266-compliant DDR
Modules. When this motherboard operate at 133Mhz, most system will not even
boot if non-compliant modules are used because of the strict timing issues, if your
SDR Modules are not DDR266-compliant, set the DDR SDRAM clock to 100MHz
to ensure system stability.
2-5 Expansion Cards
WARNING!
Turn off your power when adding or removing expansion cards or other system
components. Failure to do so may cause severe damage to both your motherboard
and expansion cards.
Figure 2-4
