40
The default setting is: [1].
*This item may or may not show up, depending on different configuration.
USB Configuration
Press [Enter] to make settings for the following sub-items:
USB Configuration
Legacy USB Support
The optional settings are: [Enabled]; [Disabled]; [Auto].
[Enabled]:
To enable legacy USB support.
[Disabled]
: To keep USB devices available only for EFI specification,
[Auto]:
To disable legacy support if no USB devices are connected.
XHCI Hand-off
This is a workaround for OSes without XHCI hand-off support. The XHCI
ownership change should be claimed by XHCI driver.
The optional settings are: [Enabled]; [Disabled].
USB Mass Storage Driver Support
The optional settings are: [Disabled]; [Enabled].
PS2 KB/MS Enable
Use this item to enable or disable PS/2 keyboard/mouse function.
The optional settings are: [Disabled]; [Enabled].
USB Hardware Delays and Time-outs:
USB Transfer Time-out
Use this item to set the time-out value for control, bulk, and interrupt transfers.
The optional settings are: [1 sec]; [5 sec]; [10 sec]; [20 sec].
Device Reset Time-out
Use this item to set USB mass storage device start unit command time-out.
The optional settings are: [10 sec]; [20 sec]; [30 sec]; [40 sec].
Device Power-up Delay
Use this item to set maximum time the device will take before it properly reports
itself to the host controller.
The optional settings: [Auto]; [Manual].
‘Auto’ uses default value: for a root port it is 100 ms, for a hub port the delay is
Содержание NF835 Series
Страница 10: ...5 Jumper Positions JP1 AT_COPEN JP3 JP4 JP2 JBAT...
Страница 24: ...19 GPIO 10 pin GPIO Header GPIO40 Pin1 2 GPIO42 GPIO44 GPIO46 GND GPIO41 GPIO43 GPIO45 GPIO47 VCC GPIO...
Страница 30: ...25 WLAN_LED 4 pin Wi Fi Bluetooth Activity LED Header WIFI_LED Pin1 2 BT_LED WIFI_LED BT_LED 3 4 WLAN_LED...
