30
Change Settings
Use this item to select an optimal setting for super IO device. Changing setting
may conflict with system resources.
WatchDog Reset Timer
Use this item to enable or disable WDT reset function.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
WatchDog Reset Timer Value
User can select a value in the range of [10] to [255] seconds when ‘
WatchDog
Reset Timer Unit
’ set as [Sec]; or in the range of [1] to [255] minutes when
‘
WatchDog Reset Timer Unit
’ set as [Min].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
The optional settings: [Disabled]; [Enabled].
When set as [Enabled], system will detect if COPEN has been short or not
(refer to
Page 9
COPEN jumper for case open detection);
if COPEN is short, system will
show Case Open Message during POST.
PC Health Status
Press
[Enter]
to view current hardware health status, or make further settings in
‘
SmartFAN Configuration
’.
►
SmartFAN Configuration
Press [Enter] to make settings for SmartFan Configuration:
SmartFAN Configuration
CPUFAN / SYSFAN Smart Mode
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
CPUFAN / SYSFAN Full-Speed Temperature
Use this item to set CPUFAN/SYSFAN full speed temperature. Fan will run at full
speed when above this pre-set temperature.
