Web Management User Guide
7
securely attached.
3.4 Plugging in the AC Power Cord
Users may now connect the AC power cord into the rear of the switch and to an electrical outlet
(preferably one that is grounded and surge protected).
Power Failure
As a precaution, the switch should be unplugged in case of power failure. When power is resumed,
plug the switch back in.
3.5 Connecting Ethernet Interface
Use switch’s UTP to connect to other Ethernet terminals. Refer to the following chart:
UTP port explanation for Fast Ethernet is shown as follows:
Pin NO.
Description
Name
Note
1
Data transmission positive
TPTXD+
Output
2
Data transmission negative
TPTXD-
Output
3
Data receive positive
TPRXD+
Input
6
Data receive negative
TPRXD-
Input
UTP port explanation for Gigabit Ethernet is shown as follows:
Содержание JRL116M-2F-M
