35
The optional settings are: [Disabled]; [Enabled].
*When set as
[Enabled]
, user can make further settings in the following items:
Change Settings
Use this item to select an optimal setting for super IO device. Changing setting
may conflict with system resources.
WatchDog Reset Timer
Use this item to enable or disable WDT reset function.
*When set as [
Enabled
], the following sub-items shall appear:
WatchDog Reset Timer Value
User can set a value in the range of [4] to [255].
WatchDog Reset Timer Unit
The optional settings are: [Sec.]; [Min.].
ATX Power Emulate AT Power
This item support Emulate AT power function, MB power On/Off control by power
supply. Use needs to select ‘AT or ATX Mode’ on MB jumper at first (refer to
Page
12
, Pin 1&2 of AT_COPEN jumper for ATX Mode & AT Mode Select).
Case Open Detect
Use this item to detect case has already open or not, show message in POST.
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], system will detect if COPEN has been short or not (refer to
Page 13
, Pin 3&4 of AT_COPEN jumper for Case Open Detection); if Pin 3&4 of
AT_COPEN is short, system will show Case Open Message during POST.
PC Health Status
Press [Enter] to view current hardware health status, make further settings in
‘
SmartFAN Configuration
’ and set value in ‘
Shutdown Temperature
’.
►
SmartFAN Configuration
Press [Enter] to make settings for ‘
SmartFan Configuration
’:
SmartFAN Configuration
CPUFAN / SYSFAN Smart Mode
The optional settings are: [Disabled]; [Enabled].
When set as [Enabled], the following sub-items shall appear:
