JETWAY BX2000, Руководство пользователя

Страница: 21 / 46

Mode = 1 min., and HDD Power Down = 1 min.
User Defined Allows you to set each mode individually. When not disabled,
each of the ranges are from 1 min. to 1 hr. except for HDD Power
Down which ranges from 1 min. to 15 min. and disable.

PM Control APM: When enabled, an Advanced Power Management device will be
activated to enhance the Max. Power Saving mode and stop the CPU internal clock.
If the Max. Power Saving is not enabled, this will be preset to No .

Video Off Method: This determines the manner in which the monitor is blanked.
V/H SYNC+Blank This selection will cause the system to turn off the vertical and
horizontal synchronization ports and write blanks to the video buffer.
Blank Screen This option only writes blanks to the video buffer.
DPMS Initial display power management signaling.

Video Off After: When enabled, this feature allows the VGA adapter to operate in a
power saving mode.
N/A Monitor will remain on during power saving modes.
Suspend Monitor blanked when the systems enters the Suspend mode.
Standby Monitor blanked when the system enters Standby mode.
Doze Monitor blanked when the system enters any power saving mode.
 MODEM Use IRQ:
Name the interrupt request (IRQ) line assigned to the modem (if any) on your
system. Activity of the selected IRQ always awakens the system.
The choices: NA, 3, 4, 5, 7, 9, 10, 11

PM Timer: The following four modes are Green PC power saving functions which are only
user configurable when User Defined Power Management has been selected see above for
available selections.

Doze Mode: When enabled and after the set time of system inactivity, the CPU clock will
run at slower speed while all other devices still operate at full speed.

Standby Mode: When enabled and after the set time of system inactivity, the fixed disk
drive and the video would be shut off while all other devices still operate at full speed.

Suspend Mode: When enabled and after the set time of system inactivity, all devices except
the CPU will be shut off.

HDD Power Down: When enabled and after the set time of system inactivity, the hard disk
drive will be powered down while all other devices remain active.

Throttle Duty Cycle: When the system enters Doze mode, the CPU clock runs only part of
the time. You may select the percent of time that the clock runs.
The Choice: 12.5%, 25.0%, 37.5%, 50.0%, 62.5%, 75.0%

ZZ Active in Suspend: When Enabled, the ZZ signal is active during Suspend mode.
The Choice: Enabled, Disabled.

VGA Active Monitor: When Enabled, any video activity restarts the global timer for Standby
mode.
The Choice: Enabled, Disabled.
20