10
2-4 Install Memory
This motherboard provides
two
184-pin DUAL INLINE MEMORY MODULES (DIMM)
sites for memory expansion available from minimum memory size of 64MB to maximum
memory size of 2.0GB DDR SDRAM.
WARNING!
Due to Intel 865 chipset specification limitation this motherboard can not support
8Mx16/16Mx16/32Mx16 Double Side memory Module.
Valid Memory Configurations
Bank
184-Pin DIMM
PCS
Total Memory
Bank 0, 1 (DDR1) DDR200/DDR266/DDR333/DDR400
DDR SDRAM Module
X1
64MB
∼
1.0GB
Bank 2, 3 (DDR2)
DDR200/DDR266
/
DDR333/DDR400
DDR SDRAM Module
X1
64MB
∼
1.0GB
Total
System Memory (Max. 2.0GB)
2
64MB
∼
2.0GB
Generally, installing DDR SDRAM modules to your motherboard is very easy, you can refer
to figure 2-4 to see what a 184-Pin DDR200/DDR266/DDR333/DDR400 DDR SDRAM
module looks like.
DDR2 (
BANK2+
BANK3)
DDR1 (
BANK0+
BANK1)
NOTE!
When you install DIMM module fully into the DIMM socket the eject tab should be
locked into the DIMM module very firmly and fit into its indention on both sides.
WARNING!
For the DDR SDRAM CLOCK is set at 200MHz, use only DDR400-compliant DDR
Modules. When this motherboard operate at 200MHz, most system will not even
boot if non-compliant modules are used because of the strict timing issues, if your
SDR Modules are not DDR400-compliant, set the DDR SDRAM clock to 166MHz
to ensure system stability.
2-5 Expansion Cards
WARNING!
Turn off your power when adding or removing expansion cards or other system
components. Failure to do so may cause severe damage to both your motherboard
and expansion cards.
2-5-1 Procedure For Expansion Card Installation
Figure 2-4
