16
(5)
Serial Port COM1: COM1
COM1 is the 9-pin D-Subminiature mail connector. The On-board serial port can be
disabled through BIOS SETUP. Please refer to Chapter 3 “INTEGRATED PERIPHERALS
SETUP“ section for more detail information.
(6)
VGA Connector (15-pin female): VGA
VGA
Connector is a 15-pin D-Subminiature Receptacle connector.
This connector is for connection Monitor and System to display.
(7)
LAN Port Connector: LAN1, LAN2
These connectors are standard RJ45 connector for Network supports 10/100 BASE-T
transfer rate.
(8)
Audio Connector: LINE-OUT, MIC
This Connector are 2 phone Jack for LINE-OUT, MIC.
Line-out :
Audio output to speaker
MIC :
Microphone Connector
(9) Floppy drive Connector (34-pin block): FDC1
This connector supports the provided floppy drive ribbon cable. After connecting
the single plug end to motherboard, connect the two plugs at other end to the
floppy drives.
Pin 1
Floppy Drive Connector
(10) Primary IDE Connector (40-pin block): IDE1
This connector supports the provided IDE hard disk ribbon cable. After connecting the
single plug end to motherboard, connect the two plugs at other end to your hard disk(s).
If you install two hard disks, you must configure the second drive to Slave mode by
COM1 LINE-OUT
MIC
PS/2
MOUSE
PS/2
Keyboard
USB
VGA
LAN1
LAN2
