© 2017 Jetta Corporation
.
All rights reserved. REV 01/2017
WWW.JETTACORP.COM
1(800) 288-7771
OWNER'S MANUAL
Operating Instructions for Walk-In Baths:
CAUTION: DO NOT OPERATE THE WHIRLPOOL AIR SYSTEM WITH ANY PARTS OR FITTINGS REMOVED
1.
Use this unit only for its intended use as described in the manual.
2.
To avoid injury, exercise care when entering or exiting the bathtub The floor may be slippery.
3.
Do not use the door as a support while entering or exiting the bathtub, as the door may swing with applied weight and
cause injury or damage to the door/hinge.
4.
Do not open door until all water has been drained from bathtub.
5.
Be careful while exiting tub Water on the floor or in the tub may cause slippery conditions.
6.
Enter your bathtub and latch the door securely. The downward motion of the door level locks and seals the door.
7.
Be certain tub drain is open, as the initial water coming from tub spout may be too cold or too hot. Carefully test
water temperature by slowly moving hand into the water stream.
8.
After adjusting water temperature, move the drain valve handle all the way to close the tub drain.
9.
The Bath Door should be left open when the tub is not in use. This allows the door seal to relax and
resume its natural shape and flexibility.
10.
It is especially important to wipe down the door seal and door jamb after each use in order to maintain
the integrity of the water seal. In order to keep the door seal and door jamb clean so it does not
accumulate dirt or debris of any kind, clean seal and jamb with a mild detergent and warm water using
a soft cloth.
Operating Instructions for Whirlpool Baths:
1. See Page 6 for Operation of Classic, Designer and Elite Jets
Operating Instructions for Air Baths:
1.
See Page 7 & 8 for Operation of Air Baths.
Operating Instructions for ActiveDrain System:
DESCRIPTION OF OPERATION
1.
The Jetta ActiveDrain is a pump assisted drain system that significantly reduces the drain time on a walk-in tub so that
the bather does not remain seated in the tub for an extended period while the tub drains.
2.
The ActiveDrain is operated by an air switch mounted on the deck of the tub. Once the bather has completed their bath,
they will depress the air switch, activating the drain pump. For fastest draining, the floor drain should remain closed while
the ActiveDrain is in operation.
3.
Once the water level is below the tub door, the ActiveDrain system can be turned off. The bather can then exit the tub
and open the floor drain to remove the remaining bath water.
4.
The ActiveDrain system requires a separate GFI protected 20 amp electrical circuit.
OPERATION INSTRUCTIONS
:$/.,1%$7+6